Re: [CAD_CAM_EDM_DRO] Re: PIC Monitor Driver.

Bill, etal,
Perhaps the local library would still have it on file?

wanliker@... wrote:

>
> In a message dated 10/21/00 7:03:09 AM Mountain Daylight Time,
> wbbengtsson@... writes:
>
> <<
> In the august 1999 issue of Silicon Chip(Australia) there is a project to
> build a box to generate a test pattern to check if a computer monitor is OK.
> They acknowledge that the article was adapted from an article in the
> American magazine Popular Electronics, May 1999 issue.
> >>
> Would anyone on the list have this issue available.
> Thanks,
> bill
>
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@egroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
> List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
> Moderator: jmelson@... [Moderator]
> URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
> FAQ: http://www.ktmarketing.com/faq.html
> bill,
> List Manager

--
-==Rich=-=Colorado Midland Railway=-=cmsteam@...=-Atlanta-
----------Moseley Dynamo Repair, Rebuild, Update Service----------