RE: Another one in the EMC stepper club

I tried the command on the file, but looking at the output I am not sure
what is right and wrong.

Any ideas on how I interpret it?

Thanks


Tim
[Denver, CO]

> -----Original Message-----
> From: Bill Martin [mailto:wwm@...]
> Sent: Monday, July 12, 1999 7:44 PM
> To: CAD_CAM_EDM_DRO@onelist.com
> Subject: Re: [CAD_CAM_EDM_DRO] Another one in the EMC stepper club
>
>
> From: Bill Martin <wwm@...>
>
> Tim Goldstein wrote:
> >
> >snip<
>
> Sounds like you have some non-printing (invisible) characters in your
> file.
> Take a look at the file with this command and you might be able to find
> the
> offending critters: od -c | more (or less) :-)
>
> Bill Martin
> >
> > The moral of the story is, I have now seen a few occasions
> where files in
> > Linux look exactly correct, but will not run right. I
> experienced this with
> > the run.64step378 file I downloaded from Matt Shaver's web
> site. The only
> > way I have found to correct this is to create a new file (not a
> copy of the
> > one that is causing the trouble). I have been successful in
> making a copy of
> > a different file that has most of what I need and then cutting
> and pasting
> > the differences from the "corrupt" file.
> >
>
> --------------------------- ONElist Sponsor ----------------------------
>
> Campaign 2000 is here!
> http://www.onelist.com
> Discuss your thoughts; get informed at ONElist. See our homepage.
>
> ------------------------------------------------------------------------
> Welcome to CAD_CAM_EDM_DRO@...,an unmodulated list for
> the discussion of shop built systems in the above catagories.
> To Unsubscribe, read archives, change to or from digest.
> Go to: http://www.onelist.com/isregistered.cgi
> Log on, and you will go to Member Center, and you can make changes there.
> bill,
> List Manager
>