Re: [CAD_CAM_EDM_DRO] Brand new to the group

Welcome to the group Richard. I take it you didn't go further than the basic
design of EDM - i.e. you didn't add on the frequency control bit.

Ian
--
Ian W. Wright
Sheffield UK
www.iw63.freeserve.co.uk

----- Original Message -----
From: "Richard " <phrh@...>
To: <CAD_CAM_EDM_DRO@egroups.com>
Sent: 02 November 2000 19:50
Subject: [CAD_CAM_EDM_DRO] Brand new to the group


> At this time it seems I must do plenty of reading just to get on
> board with you guys. I did build the EDM setup somewhat like Langlois
> described. I followed his instructions for the stepping motor feed