Re: Brand new to the group

The Home Shop Machinist magazine had a series of articles by Robert
Langlois starting with the May/June 1995 issue. The author also has a
book available showing the entire set of plans for about 18 bucks. It
is a real nice project. Richard

--- In CAD_CAM_EDM_DRO@egroups.com, "Smoke" <Smoke@5...> wrote:
> Where was it you found those plans again? I might want to try
building one of these to use EDM for machining rectangular
breechblock holes in some rifle actions.
>
> Smoke
>
> -
>
>
> At this time it seems I must do plenty of reading just to get on
> board with you guys. I did build the EDM setup somewhat like
Langlois
> described.
>
>
> [Non-text portions of this message have been removed]