Re: [CAD_CAM_EDM_DRO] Re: Brand new to the group

I have that Langolis EDM book. It's great!!

Richard wrote:

> The Home Shop Machinist magazine had a series of articles by Robert
> Langlois starting with the May/June 1995 issue. The author also has a
> book available showing the entire set of plans for about 18 bucks. It
> is a real nice project. Richard
>
> --- In CAD_CAM_EDM_DRO@egroups.com, "Smoke" <Smoke@5...> wrote:
> > Where was it you found those plans again? I might want to try
> building one of these to use EDM for machining rectangular
> breechblock holes in some rifle actions.
> >
> > Smoke
> >
> > -
> >
> >
> > At this time it seems I must do plenty of reading just to get on
> > board with you guys. I did build the EDM setup somewhat like
> Langlois
> > described.
> >
> >
> > [Non-text portions of this message have been removed]
>
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@egroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
> List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
> Moderator: jmelson@... [Moderator]
> URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
> FAQ: http://www.ktmarketing.com/faq.html
> bill,
> List Manager