CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Brand new to the group

Posted by Smoke
on 2000-11-02 11:59:27 UTC
Where was it you found those plans again? I might want to try building one of these to use EDM for machining rectangular breechblock holes in some rifle actions.

Smoke

-


At this time it seems I must do plenty of reading just to get on
board with you guys. I did build the EDM setup somewhat like Langlois
described.


[Non-text portions of this message have been removed]

Discussion Thread

Richard 2000-11-02 11:52:41 UTC Brand new to the group Smoke 2000-11-02 11:59:27 UTC Re: [CAD_CAM_EDM_DRO] Brand new to the group Ian Wright 2000-11-02 12:09:01 UTC Re: [CAD_CAM_EDM_DRO] Brand new to the group Richard 2000-11-02 13:12:32 UTC Re: Brand new to the group Joe Vicars 2000-11-02 13:23:17 UTC Re: [CAD_CAM_EDM_DRO] Re: Brand new to the group cnc4me@u... 2000-11-02 13:59:36 UTC Re: Brand new to the group cnc4me@u... 2000-11-02 14:15:26 UTC Re: Brand new to the group Richard 2000-11-02 16:18:08 UTC Re: Brand new to the group Richard 2000-11-03 07:54:14 UTC Re: Brand new to the group Jon Elson 2000-11-03 13:56:52 UTC Re: [CAD_CAM_EDM_DRO] Re: Brand new to the group Richard 2000-11-03 15:41:31 UTC Re: Brand new to the group Jon Elson 2000-11-03 16:47:22 UTC Re: [CAD_CAM_EDM_DRO] Re: Brand new to the group