CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Drop, was Re: Anvils

Posted by dave engvall
on 2000-11-03 17:00:41 UTC
Randy Gordon-Gilmore wrote:

> Oh shoot, given that height gravitational acceleration isn't a constant.
> Never mind. I don't want to have to integrate (not that I'd remember
> without consulting a book...)
>
> Randy
>

If 3.0 E 12 m is the upper bound since it assumes constant gravity then there are other problems. Such as which planet is most
likely to capture the anvil. At 3.0 E 9 kilometers the distance to some pretty massive objects is less than the distance to earth.
Just depends on where they are in their orbit. :-O

Dave

Discussion Thread

Anne Ogborn 2000-11-03 09:55:52 UTC Anvils Smoke 2000-11-03 10:01:12 UTC Re: [CAD_CAM_EDM_DRO] Anvils Jon Anderson 2000-11-03 10:27:10 UTC Re: [CAD_CAM_EDM_DRO] Anvils paul@a... 2000-11-03 10:46:25 UTC Re: [CAD_CAM_EDM_DRO] Anvils Smoke 2000-11-03 10:52:55 UTC Re: [CAD_CAM_EDM_DRO] Anvils Hugh Prescott 2000-11-03 11:29:19 UTC Re: [CAD_CAM_EDM_DRO] Anvils Hugh Prescott 2000-11-03 11:30:36 UTC Re: [CAD_CAM_EDM_DRO] Anvils Darrell 2000-11-03 13:50:47 UTC Re: [CAD_CAM_EDM_DRO] Anvils Anne Ogborn 2000-11-03 16:00:08 UTC Re: [CAD_CAM_EDM_DRO] Anvils Anne Ogborn 2000-11-03 16:11:19 UTC Re: [CAD_CAM_EDM_DRO] Anvils Randy Gordon-Gilmore 2000-11-03 16:22:02 UTC Re: Anvils Randy Gordon-Gilmore 2000-11-03 16:26:33 UTC Drop, was Re: Anvils Randy Gordon-Gilmore 2000-11-03 16:32:05 UTC Drop, was Re: Anvils dave engvall 2000-11-03 17:00:41 UTC Re: [CAD_CAM_EDM_DRO] Drop, was Re: Anvils ballendo@y... 2000-11-03 18:17:00 UTC re:Re: Anvils JanRwl@A... 2000-11-03 19:14:09 UTC Re: [CAD_CAM_EDM_DRO] Anvils ballendo@y... 2000-11-03 19:34:14 UTC Re: Anvils Darrell 2000-11-04 00:06:52 UTC Re: [CAD_CAM_EDM_DRO] re:Re: Anvils Smoke 2000-11-04 08:46:51 UTC Re: [CAD_CAM_EDM_DRO] re:Re: Anvils Anne Ogborn 2000-11-04 10:26:34 UTC Re: [CAD_CAM_EDM_DRO] Drop, was Re: Anvils Andrew Werby 2000-11-04 12:19:24 UTC Re: Anvils ballendo@y... 2000-11-04 14:45:59 UTC Re: Anvils Smoke 2000-11-04 15:09:44 UTC Re: [CAD_CAM_EDM_DRO] Re: Anvils