CAD CAM EDM DRO - Yahoo Group Archive

Re: Cheap Encoders

on 1999-07-15 10:44:00 UTC
Does anyone have any thoughts about using these low cost rotary encoders
from Goldmine attached to the TABLE ( or quill ) instead of the SCREWS.

Maybe by some sort of belt or wire driving a pulley with a spring to
keep it all under tension ?

By attaching it to the table, any lash in the driving mechanism would then
be accounted for automatically, similar to using linear encoders.

Alan

--

Alan Rothenbush | The Spartans do not ask the number of the
Academic Computing Services | enemy, only where they are.
Simon Fraser University |
Burnaby, B.C., Canada | Agix of Sparta

Discussion Thread

Alan Rothenbush 1999-07-15 10:44:00 UTC Re: Cheap Encoders Brad Heuver 1999-07-15 11:26:49 UTC Re: Cheap Encoders Dan Mauch 1999-07-15 12:41:17 UTC Re: Re: Cheap Encoders Matt Shaver 1999-07-15 13:38:21 UTC Re: Re: Cheap Encoders Matt Shaver 1999-07-15 13:53:57 UTC Re: Re: Cheap Encoders Jon Elson 1999-07-15 14:54:35 UTC Re: Re: Cheap Encoders mike grady 1999-07-15 16:23:02 UTC Re: Re: Cheap Encoders Scott Acorn 1999-07-15 18:05:44 UTC Re: Re: Cheap Encoders Don Hughes 1999-07-15 21:23:33 UTC Re: Re: Cheap Encoders Jim GREGG 1999-07-15 21:46:39 UTC Re: Re: Cheap Encoders Don Hughes 1999-07-15 21:51:28 UTC Re: Re: Cheap Encoders WAnliker@x... 1999-07-15 21:53:53 UTC Re: Re: Cheap Encoders Jon Elson 1999-07-15 22:27:37 UTC Re: Re: Cheap Encoders Don Hughes 1999-07-15 22:20:10 UTC Re: Re: Cheap Encoders John Grant 1999-07-15 23:52:51 UTC Re: Re: Cheap Encoders