CAD CAM EDM DRO - Yahoo Group Archive

welding linear shafts

on 2000-11-29 11:58:38 UTC
Considering that linear shafting, even Thompson, is reasonably priced unless you want mounting holes drilled and tapped...

Any reason I can't weld mounts on the shaft? Assuming I take reasonable precautions to keep the shaft clean?

I realize I'll be changing the hardness of the shaft with the heat... but how many cnc machines fail because the shaft isn't hard enough?

I'm more concerned with the bending of the shaft caused by uneven heating, if I was to weld supports in the center of the shaft (for use with open bearings)

Richard Spelling, http://www.spellingbusiness.com/boats
From the muddy waters of Oklahoma



[Non-text portions of this message have been removed]

Discussion Thread

Richard Spelling 2000-11-29 11:58:38 UTC welding linear shafts Smoke 2000-11-29 12:22:46 UTC Re: [CAD_CAM_EDM_DRO] welding linear shafts Jon Elson 2000-11-29 15:59:05 UTC Re: [CAD_CAM_EDM_DRO] welding linear shafts Fred Smith 2000-11-29 16:19:54 UTC Re: welding linear shafts ballendo@y... 2000-11-29 17:41:54 UTC re:welding linear shafts ballendo@y... 2000-11-29 17:41:55 UTC re:welding linear shafts zeff1015@a... 2000-11-29 20:54:24 UTC Re: [CAD_CAM_EDM_DRO] welding linear shafts Smoke 2000-11-29 21:01:43 UTC Re: [CAD_CAM_EDM_DRO] re:welding linear shafts Smoke 2000-11-29 21:15:53 UTC Re: [CAD_CAM_EDM_DRO] welding linear shafts JanRwl@A... 2000-11-29 22:49:02 UTC Re: [CAD_CAM_EDM_DRO] welding linear shafts Kevin P. Martin 2000-11-30 06:40:15 UTC RE: [CAD_CAM_EDM_DRO] welding linear shafts diazden 2000-11-30 22:19:52 UTC Re: [CAD_CAM_EDM_DRO] welding linear shafts Smoke 2000-11-30 22:39:07 UTC Re: [CAD_CAM_EDM_DRO] welding linear shafts