Re: [CAD_CAM_EDM_DRO] welding linear shafts

Even tho' I suggested a possible welding technique, I prefer using bolts.

Smoke


-----Original Message-----
From: zeff1015@... <zeff1015@...>
To: CAD_CAM_EDM_DRO@egroups.com <CAD_CAM_EDM_DRO@egroups.com>
Date: Wednesday, November 29, 2000 9:54 PM
Subject: Re: [CAD_CAM_EDM_DRO] welding linear shafts

>I think Jon's right about just drilling holes yourself. Also remember to
>keep the shaft cool while drilling (LOTS of heat can be generated while
>drilling!)
>
>If this won't work and you're really stuck on the welding thing, you might
>want to try brazing instead. You would apply slightly less heat to the
>shaft, and if done right the tensile strength of a brazed joint is higher
>than most welds.
>
>Hope this gives you some more ideas.
>
>Jeff
>
>Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the

discussion of shop built systems, for CAD, CAM, EDM, and DRO.

>
>Addresses:
>Post message: CAD_CAM_EDM_DRO@egroups.com
>Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
>Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
>List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
>Moderator: jmelson@... [Moderator]
>URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
>FAQ: http://www.ktmarketing.com/faq.html
>bill,
>List Manager
>
>
>