Re: [CAD_CAM_EDM_DRO] Re: real granite machines!
Posted by
Jon Elson
on 2000-12-01 15:07:36 UTC
Ian Wright wrote:
not sure that would be much good for structural purposes.
Jon
> Hi Marcus,Stone facing is rarely over 1" thick, often even thinner than that. I'm
>
> While I was out today I had another thought for a source of the stone you
> want. Shopfitters. I noticed a building near me where they were tearing off
> the marble / granite? facings to replace them during a facelift of the
> frontage. So the chances are that this old stone would be available at a
> reasonable price (probably free) and you could then hire a diamond cutting
> disk to trim it to size. It is, of course, polished already on one face.
> Demolition yards are another possible source. HTH,
not sure that would be much good for structural purposes.
Jon
Discussion Thread
Jon Elson
2000-11-29 21:24:34 UTC
Re: real granite machines!
dave engvall
2000-11-30 07:02:21 UTC
Re: [CAD_CAM_EDM_DRO] Re: real granite machines!
Joe Vicars
2000-11-30 07:12:44 UTC
Re: [CAD_CAM_EDM_DRO] Re: real granite machines!
Marcus & Eva
2000-11-30 08:23:48 UTC
Re: [CAD_CAM_EDM_DRO] Re: real granite machines!
Smoke
2000-11-30 10:55:56 UTC
Re: [CAD_CAM_EDM_DRO] Re: real granite machines!
Randy Gordon-Gilmore
2000-11-30 11:31:15 UTC
Re: real granite machines!
John D. Guenther
2000-11-30 11:45:56 UTC
Re: real granite machines!
Doug Harrison
2000-11-30 13:04:36 UTC
Re: [CAD_CAM_EDM_DRO] Re: real granite machines!
ballendo@y...
2000-11-30 20:04:39 UTC
Re: Re: real granite machines!
dave engvall
2000-11-30 20:41:58 UTC
Re: [CAD_CAM_EDM_DRO] Re: real granite machines!
dave engvall
2000-11-30 20:42:23 UTC
Re: [CAD_CAM_EDM_DRO] Re: Re: real granite machines!
Ian Wright
2000-12-01 01:04:59 UTC
Re: [CAD_CAM_EDM_DRO] Re: real granite machines!
Jon Elson
2000-12-01 15:07:36 UTC
Re: [CAD_CAM_EDM_DRO] Re: real granite machines!