RE: [CAD_CAM_EDM_DRO] Re: Mill DRO

Because I'm new to the list, and I am (was) sure that this has been
discussed a thousand times. I guess I was wrong.

Kory

> -----Original Message-----
> From: Wally K [mailto:cnc4me@...]
> Sent: Saturday, December 16, 2000 6:19 PM
> To: CAD_CAM_EDM_DRO@egroups.com
> Subject: [CAD_CAM_EDM_DRO] Re: Mill DRO
>
>
> --- In CAD_CAM_EDM_DRO@egroups.com, "Kory Hamzeh" <kory@a...> wrote:
> > Art,
> Why would you want to take this subject off list.
> this is what this list is for.
>
>
> Wally K.
>
>
>
> >
> > Can you send me some info on your setup? We should probably take
> this off of
> > the list so we don't bore everyone. I can be reached at kory@a...
> >
> > Thanks,
> > Kory
> >
> >
> > > -----Original Message-----
> > > From: A. G. Eckstein [mailto:axtein@s...]
> > > Kory,
> > > I have to disagree with you on the cost of the home brew stuff.
> > >
> > > I built the 3 axis DRO on my mill for less than $200 INCLUDING
> the used
> > > 486DX100 and monitor that I purchased for this purpose.
>
>
>
>
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for
> the discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@egroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
> List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
> Moderator: jmelson@... [Moderator]
> URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
> FAQ: http://www.ktmarketing.com/faq.html
> bill,
> List Manager
>
>