Re: [CAD_CAM_EDM_DRO] Pendant

New challenge, fix up the system so you can use an infrared remote control.
This way you can be anywhere around the machine and adjust it. Just be
careful it's not on while you're watching TV :-)

-Greg

----- Original Message -----
From: "Smoke" <Smoke@...>
To: <CAD_CAM_EDM_DRO@egroups.com>
Sent: Monday, December 18, 2000 3:22 PM
Subject: Re: [CAD_CAM_EDM_DRO] Pendant


> I understand what your all saying now...but I'd call it a set of remote
> controls because they don't necessarily need to be mounted in a box on the
> end of a wire. You could mount the box in a fixed postion.....which is
what
> I'd do becasuse I find those boxes hanging from wires tend to get in the
way
> and can cause accidents.
>
> Smoke
>
> >A "pendant" is a remote control panel which allows you to operate your
> >machine without having to go to the PC keyboard each time.
>
>
>
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@egroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
> List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
> Moderator: jmelson@... [Moderator]
> URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
> FAQ: http://www.ktmarketing.com/faq.html
> bill,
> List Manager
>