RE: [CAD_CAM_EDM_DRO] Pendant

> Hi All,
>
> A little advice please. I am building a PIC based pendent which is user
> programmable as to out-put speed. It should hook up to any system that
> takes
> step and direction pulses and will drive 4 axis. You will have a choice of
> single step and then three speeds from a list of twelve. What would be the
> slowest and the highest speeds that would be most useable. This device
> will
> drive any machine from Lathe, miller to router. I realise that the router
> people would like a top speed around 600 ipm but I am limiting it to about
> 200 ipm on this version. There will be a completely programmable pendant
> once this one is completed.
>
> Terry
>
>
>
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
> discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@egroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
> List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
> Moderator: jmelson@... [Moderator]
> URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
> FAQ: http://www.ktmarketing.com/faq.html
> bill,
> List Manager
>