Re: [CAD_CAM_EDM_DRO] info needed

Yes you could but It would not be efficient for running production work.
Please Visit Our Website @ http://www.virtualmachinist.com and
http://www.machinistsoftware.com and http://www.copco.net

----- Original Message -----
From: "Smoke" <Smoke@...>
To: <CAD_CAM_EDM_DRO@egroups.com>
Sent: Wednesday, December 20, 2000 3:02 PM
Subject: Re: [CAD_CAM_EDM_DRO] info needed


> Can't you just use your regular finish turn program and simply "lie to the
> machine"...tell it the tool bit is closer to centerline than it really is.
> After the "rough turn" cycle, reset the tool position and do the finish
> turning.
>
> Smoke
>
>
> >Does anyone know of any software available For turning that can
> >figure a rough turn cycle in steps for a machine that does not have a
> >rough canned cycle? something that all you have to do is input
> >Dimensions like lqc2000 AKA lathe quick code 2000
> >Bill
> >
> >
>
>
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@egroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
> List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
> Moderator: jmelson@... [Moderator]
> URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
> FAQ: http://www.ktmarketing.com/faq.html
> bill,
> List Manager
>
>