Re: [CAD_CAM_EDM_DRO] Re: MAX NC pinout

Terry,

Yeah, you're right! That's what I meant in my second post! I'm sure
you know, but you can check it out with a 'scope, probably only make the
motors run funny!

Alan KM6VV

Terry May wrote:

>
> Alan,
> I don't know which would be called reversed, I guess it's just a
> point of view thing. As I said I got the pin outs I listed from the
> EMC site ( www.isd.mel.nist.gov/projects/emc/emcsoft.html ) so I
> assume they will be correct for systems using EMC. At least I hope
> so, if not I will soon be re-inventing the magic smoke machine!
> Terry
>
> --- In CAD_CAM_EDM_DRO@egroups.com, Alan Marconett KM6VV <KM6VV@a...>
> wrote:
> > Terry,
> >
> > Yes, I was referring to the pinouts I posted. One of them is
> reversed!
> > Is it MaxNC or EMC? SuperCam has a page of pinouts also, and I
> think
> > MaxNC has more then one set of 4-phase pinouts. Hopefully EMC is
> > configurable! CNCpro and others are.
> >
> > Alan KM6VV
> >
> >
> > Terry May wrote:
> > >
> > > Alan
> > >
> > > Thanks for the reply, I'm assuming you mean reversed from the MAX
> NC
> > > pinouts you provided in your earlier reply to Philp?
> > > Terry
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@egroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
> List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
> Moderator: jmelson@... [Moderator]
> URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
> FAQ: http://www.ktmarketing.com/faq.html
> bill,
> List Manager