CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] polls? was me too's?

Posted by wanliker@a...
on 2001-01-14 23:23:14 UTC
In a message dated 1/14/01 7:55:08 PM Mountain Standard Time,
kimberln@... writes:

Well, one thing that would help the entire list is to only include the points
you are answering, and also why not clean up all the list information on the
bottom of each posting.
Also when you are receiving the digest form of delivery, you must change the
subject, otherwise the digest number becomes the subject.
But I would also remind all that the most accepted postings are those that
apply to CAD, CAM, EDM, AND DRO. We all tend to digress at times, but the
list title and common sense is and should be the norm.
bill
List Mom

The following should never be copied and reposted................
<<
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@egroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
> List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
> Moderator: jmelson@... [Moderator]
> URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
> FAQ: http://www.ktmarketing.com/faq.html
> bill,
> List Manager
>>

Discussion Thread

ballendo@y... 2001-01-14 17:22:03 UTC polls? was me too's? Greg Nuspel 2001-01-14 17:41:24 UTC Re: [CAD_CAM_EDM_DRO] polls? was me too's? Jerry Kimberlin 2001-01-14 18:53:24 UTC Re: [CAD_CAM_EDM_DRO] polls? was me too's? wanliker@a... 2001-01-14 23:23:14 UTC Re: [CAD_CAM_EDM_DRO] polls? was me too's? Tony Jeffree 2001-01-15 03:17:25 UTC Re: polls? was me too's? Greg Nuspel 2001-01-15 03:51:26 UTC Re: [CAD_CAM_EDM_DRO] Re: polls? was me too's?