Re: 1/8" Shank, 1/8" Diameter Spiral Upcut bit source?

Tim,

My bad, I'm milling ONE inch down on the 1/8" cutter. I have a 1/8"
spiral DOWNCUT bit that works great (from Dremel) but it clogs up the
cut with shavings and Dremel does not make an "upcut" bit (?).

Thanks
Tracy

--- In CAD_CAM_EDM_DRO@y..., "Tim Goldstein" <timg@k...> wrote:
> Wow,
>
> 2" down on a 1/8" cutter is a recipie for flex and chatter. Anyway
to use a
> bigger mill? if not I would look for a carbide to get some
stiffness.
>
> Tim
> [Denver, CO]
>
> >Gentlemen,
> >
> > Does anyone have a source for a 1/8" Shank, 1/8" Diameter Spiral
> >Upcut bit? I've searched everywhere and can't seem to find one. The
> >closest I've come is a 1/4" shank, 1/8" diameter upcut bit. The
shank
> >needs to be 1/8" as well as I'm milling down about two inches on a
> >MaxNC-10 mill.
> >
> >Any help would be appreciated!
> >
> >Tracy Norris
> >FAQ: http://www.ktmarketing.com/faq.html
> >
> >