CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] 1/8" Shank, 1/8" Diameter Spiral Upcut bit source?

Posted by dave engvall
on 2001-01-31 19:31:31 UTC
Tim Goldstein wrote:

> Wow,
>
> 2" down on a 1/8" cutter is a recipie for flex and chatter. Anyway to use a
> bigger mill? if not I would look for a carbide to get some stiffness.

Sounds like a job for an unobtanium bit. <g>
Super light cuts with diamond ???
Dave

>
>
> Tim
> [Denver, CO]
>
> >Gentlemen,

Discussion Thread

tnorris@h... 2001-01-31 12:46:54 UTC 1/8" Shank, 1/8" Diameter Spiral Upcut bit source? Tim Goldstein 2001-01-31 13:30:40 UTC Re: [CAD_CAM_EDM_DRO] 1/8" Shank, 1/8" Diameter Spiral Upcut bit source? tnorris@h... 2001-01-31 14:56:41 UTC Re: 1/8" Shank, 1/8" Diameter Spiral Upcut bit source? ballendo@y... 2001-01-31 16:26:14 UTC Re: 1/8" Shank, 1/8" Diameter Spiral Upcut bit source? tnorris@h... 2001-01-31 17:08:27 UTC Re: 1/8" Shank, 1/8" Diameter Spiral Upcut bit source? Marcus & Eva 2001-01-31 18:42:49 UTC Re: [CAD_CAM_EDM_DRO] 1/8" Shank, 1/8" Diameter Spiral Upcut bit source? dave engvall 2001-01-31 19:31:31 UTC Re: [CAD_CAM_EDM_DRO] 1/8" Shank, 1/8" Diameter Spiral Upcut bit source? Jon Elson 2001-01-31 23:24:31 UTC Re: [CAD_CAM_EDM_DRO] 1/8" Shank, 1/8" Diameter Spiral Upcut bit source?