Re: 1/8" Shank, 1/8" Diameter Spiral Upcut bit source?

Tracy,

Try: http://www.micro100.com

Go to endmills. Then to 30 degree high performance type 1/8" cut dia.
1/2" flute length, 1-1/2" oal.

They may offer others. I just wanted to be sure thay had at least
part of waht you asked for :-)

Hope this helps.

Ballendo

BTW, most machine shop supply houses carry these, or can order them
in.

> My bad, I'm milling ONE inch down on the 1/8" cutter. I have a
> 1/8" spiral DOWNCUT bit that works great (from Dremel) but it clogs
> up the cut with shavings and Dremel does not make an "upcut" bit