Re: [CAD_CAM_EDM_DRO] Simple Stepper Motor Control Software
Posted by
Alan Marconett KM6VV
on 2001-02-07 21:46:38 UTC
Hi John,
You might try these sites for free software.
http://www.wokingham.demon.co.uk/prog/programming.htm
or:
http://www.metalworking.com/shareware.html CNC979 source.
Alan KM6VV
keenlyside831@... wrote:
You might try these sites for free software.
http://www.wokingham.demon.co.uk/prog/programming.htm
or:
http://www.metalworking.com/shareware.html CNC979 source.
Alan KM6VV
keenlyside831@... wrote:
>
> Hi Folks
>
> I have recently completed construction and testing of Camtronics 5A
> Chopper Drivers.
>
> The eventual plan is to CNC my mill but for now I am just trying to
> get some software that would allow mw to jog, free run and move the
> steppers by a defined number of steps (basically a manual positioning
> control panel).
>
> I want to do this first to gradually get up the learning curve.
>
> Can anyone suggest some low cost or shareware software for this?
>
> Thanks
>
> John Mathews
Discussion Thread
keenlyside831@a...
2001-02-07 19:52:16 UTC
Simple Stepper Motor Control Software
Tim Goldstein
2001-02-07 20:12:32 UTC
RE: [CAD_CAM_EDM_DRO] Simple Stepper Motor Control Software
Doug Fortune
2001-02-07 21:08:29 UTC
Simple Stepper Motor Control Software
Alan Marconett KM6VV
2001-02-07 21:46:38 UTC
Re: [CAD_CAM_EDM_DRO] Simple Stepper Motor Control Software
James Owens
2001-02-08 12:57:20 UTC
Re: [CAD_CAM_EDM_DRO] Simple Stepper Motor Control Software
keenlyside831@a...
2001-02-11 19:18:13 UTC
Re: Simple Stepper Motor Control Software