Re: [CAD_CAM_EDM_DRO] Re: Taig CNC mill .......and Emco

Hi all.

One of the scary things about the EMCO lathes (the CNC 5 ) is that all the
software is in ROM in the main board - and EMCO worked by replacing the
whole board for updates - at about $1800 a throw - I've done two.

By the way I'm still trying to get hold of either copies or original
service manual for the CNC 5 with the electronics circuit diagrams. any
help out there please?

Jim Gregg

At 04:58 PM 2/19/01 -0800, you wrote:

>Chris,
>
>No clue on the FB100 mills. It the plugs are compatible, I'd suggest
>swapping motors, drivers, etc. BUT... if they are blowing the fets, not
>a good idea! 5 phase vextra motors? NEMA 23's? I know what I'D DO,
>goto to Camtronics and set them up for bipolar steppers and new
>drivers. And probably opt for CNCpro.
>
>The "damp environment" is a little scary, corrosion on connectors? rust
>on ways??
>
>Alan KM6VV
>P.S. What does an FB100 look like? Are they still available??
>