Re: [CAD_CAM_EDM_DRO] Re: G02 / G02 I and J arguments
Posted by
Art Fenerty
on 2001-02-21 14:33:09 UTC
Alan:
your right about the G02,G03, it shuld eb 2 G02'2. You only need two
because emc will see a full rotation as no rotation at all.
Master5 will import HPGL lines,polylines and arcs. I only use R-word
arcs when I export the G-Code, but Master5 understands I,J incremental as
well as absolute. It should recognise G12/G13's as well, though I haven't
tried it.
Good Luck,
Art
your right about the G02,G03, it shuld eb 2 G02'2. You only need two
because emc will see a full rotation as no rotation at all.
Master5 will import HPGL lines,polylines and arcs. I only use R-word
arcs when I export the G-Code, but Master5 understands I,J incremental as
well as absolute. It should recognise G12/G13's as well, though I haven't
tried it.
Good Luck,
Art
Discussion Thread
Larry Edington
2001-02-20 14:04:57 UTC
G02 / G02 I and J arguments
Alan Marconett KM6VV
2001-02-20 15:03:30 UTC
Re: G02 / G02 I and J arguments
ballendo@y...
2001-02-20 21:50:52 UTC
Re: G02 / G02 I and J arguments
dougrasmussen@c...
2001-02-21 06:15:51 UTC
Re: G02 / G02 I and J arguments
Art Fenerty
2001-02-21 09:28:50 UTC
Re: [CAD_CAM_EDM_DRO] G02 / G02 I and J arguments
Art Fenerty
2001-02-21 09:30:31 UTC
Re: [CAD_CAM_EDM_DRO] Re: G02 / G02 I and J arguments
Alan Marconett KM6VV
2001-02-21 12:12:13 UTC
Re: G02 / G02 I and J arguments
ledington@c...
2001-02-21 13:14:59 UTC
Re: G02 / G02 I and J arguments
ballendo@y...
2001-02-21 14:19:16 UTC
Re: G02 / G02 I and J arguments
Art Fenerty
2001-02-21 14:33:09 UTC
Re: [CAD_CAM_EDM_DRO] Re: G02 / G02 I and J arguments
Art Fenerty
2001-02-21 14:41:23 UTC
Re: [CAD_CAM_EDM_DRO] Re: G02 / G02 I and J arguments
ballendo@y...
2001-02-21 15:03:14 UTC
Re: G02 / G02 I and J arguments
Art Fenerty
2001-02-21 16:06:24 UTC
Re: [CAD_CAM_EDM_DRO] Re: G02 / G02 I and J arguments