Re: [CAD_CAM_EDM_DRO] Re: G02 / G02 I and J arguments

Ballendo:

Your right , of course, I was thinking R values.
Art

----- Original Message -----
From: <ballendo@...>
To: <CAD_CAM_EDM_DRO@yahoogroups.com>
Sent: Wednesday, February 21, 2001 2:50 PM
Subject: [CAD_CAM_EDM_DRO] Re: G02 / G02 I and J arguments


> Art,
>
> This would indicate a serious error, if using I,J,K format! In R
> format, it makes sense...
>
> G00 x0y0
> G02 x0y0 i <anything> j <anything> F <anything except 0>
>
> SHOULD make a complete circle, and NOT flag an error. The i,j values
> will set the size of the circle, and its location relative to the
> origin start/end point.
>
> Ballendo
>
> >you're right about the G02,G03, it should be 2 G02's. You only need
> >two because emc will see a full rotation as no rotation at all.
> >Art
>
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
> FAQ: http://www.ktmarketing.com/faq.html
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>