Re: [CAD_CAM_EDM_DRO] BDI EMC

Paul,

I am interested in one of your CD's. Can I set one up on a computer with
windows running on it, say on a separate drive?

Tom Eldredge, Trustee

----- Original Message -----
From: Paul <Paul.Corner@...>
To: <emc@...>; <CAD_CAM_EDM_DRO@yahoogroups.com>
Sent: Tuesday, February 20, 2001 4:17 PM
Subject: [CAD_CAM_EDM_DRO] BDI EMC


>
> Folks
>
> I've wasted too much time allready - The beta BDI EMC disks are being
burned
> tonight, and I'll ship some out tomorrow. Just one month late !!!
>
> The on screen help texts haven't been done yet - But I am confident the
install
> shell works as planned. As it stands, a complete Linux/EMC install takes
about
> 20 mins from inserting the CD to getting a working EMC box.
> Minimum requirements are:
> Pentium class processor
> 16Mb Ram
> SVGA graphics card & monitor
> 400Mb IDE drive (no SCSI support)
>
> Regards, Paul.
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
> FAQ: http://www.ktmarketing.com/faq.html
>
>