Re: EMC up and running
Posted by
Jesse Hill
on 1999-08-11 10:52:01 UTC
Dan and others,
I'm a total newbie, so please bear with
me.
I'm interested in the Linux / EMC
setup. Could I use this to get my Terco
mill and colne lathe running? They
accept G-codes.
I think I have a suitable computer setup
available, but if the price were
reasonable, I would be interested in a
pre-configured setup, as you mentioned
Dan. (I'm assuming here that this
system would work well with the
aforementioned lathe and mill).
Any help appreciated greatly.
Jesse Hill
I'm a total newbie, so please bear with
me.
I'm interested in the Linux / EMC
setup. Could I use this to get my Terco
mill and colne lathe running? They
accept G-codes.
I think I have a suitable computer setup
available, but if the price were
reasonable, I would be interested in a
pre-configured setup, as you mentioned
Dan. (I'm assuming here that this
system would work well with the
aforementioned lathe and mill).
Any help appreciated greatly.
Jesse Hill
Discussion Thread
Dan Mauch
1999-08-11 07:59:25 UTC
Re: EMC up and running
gary@x...
1999-08-11 09:04:46 UTC
Re: EMC up and running
Robert Bachman
1999-08-11 12:42:51 UTC
Re: EMC up and running
Jesse Hill
1999-08-11 10:52:01 UTC
Re: EMC up and running
Dan Mauch
1999-08-11 10:55:13 UTC
Re: EMC up and running
Dan Mauch
1999-08-11 18:36:31 UTC
Re: EMC up and running
Bob Bachman
1999-08-11 22:20:25 UTC
Re: EMC up and running
PTENGIN@x...
1999-08-11 20:59:53 UTC
Re: EMC up and running
Jon Elson
1999-08-11 23:10:58 UTC
Re: EMC up and running