Re: EMC up and running

> From: Jesse Hill <usjess@...>

> I'm interested in the Linux / EMC
> setup. Could I use this to get my Terco
> mill and colne lathe running? They
> accept G-codes.

If these machines already accept G-code, then they must
already be working CNC machines. Why switch?

I don't really understand what you are asking for, here.
Anyway, if these machines are using servo motors, you
need a lot more than just the computer. You need a
Servo-to-Go card to read the encoders, and send velocity
commands to the servo amplifiers. And, you need the
servo amps and power supplies.

For stepper control, you just need a PC parallel port and
the sepper driver units.

Jon