Re: Re: lathe arcs
Posted by
ozzietwo2001@y...
on 2001-03-18 11:56:15 UTC
I had some problems with CNCPRO at first cutting arcs using code
generated by Vector. The solution that worked for me was to change
the driver options in Vector; "Options/Driver", and uncheck all boxes
except the line that starts G00,----.
Since then the arcs are beautiful!
Hope this helps.
Jerry
generated by Vector. The solution that worked for me was to change
the driver options in Vector; "Options/Driver", and uncheck all boxes
except the line that starts G00,----.
Since then the arcs are beautiful!
Hope this helps.
Jerry
Discussion Thread
Carey L. Culpepper
2001-03-17 18:07:15 UTC
lathe arcs
Carey L. Culpepper
2001-03-17 18:54:15 UTC
lathe arcs
davemucha@j...
2001-03-17 20:20:47 UTC
Re: lathe arcs
Bill Darby
2001-03-17 20:55:18 UTC
Re: [CAD_CAM_EDM_DRO] Re: lathe arcs
Donald Brock
2001-03-17 22:05:21 UTC
Re: lathe arcs
Carey L. Culpepper
2001-03-17 23:20:39 UTC
Re: [CAD_CAM_EDM_DRO] Re: lathe arcs
ballendo@y...
2001-03-18 03:48:42 UTC
re:Re: lathe arcs
Carey L. Culpepper
2001-03-18 07:50:06 UTC
Re: [CAD_CAM_EDM_DRO] re:Re: lathe arcs
dougrasmussen@c...
2001-03-18 08:37:07 UTC
re:Re: lathe arcs
IMService
2001-03-18 09:36:19 UTC
Re: Re: Re: lathe arcs
Carey L. Culpepper
2001-03-18 09:38:29 UTC
Re: [CAD_CAM_EDM_DRO] re:Re: lathe arcs
Carey L. Culpepper
2001-03-18 10:15:59 UTC
Re: [CAD_CAM_EDM_DRO] Re: Re: Re: lathe arcs
ozzietwo2001@y...
2001-03-18 11:56:15 UTC
Re: Re: lathe arcs
Alan Marconett KM6VV
2001-03-18 13:52:16 UTC
Re: lathe arcs
ballendo@y...
2001-03-18 17:17:40 UTC
re:Re: lathe arcs
Carey L. Culpepper
2001-03-18 20:18:10 UTC
Re: [CAD_CAM_EDM_DRO] re:Re: lathe arcs
Sven Peter, TAD S.A.
2001-03-20 05:45:25 UTC
Re: [CAD_CAM_EDM_DRO] re:Re: lathe arcs
Sven Peter, TAD S.A.
2001-03-20 11:09:39 UTC
Re: [CAD_CAM_EDM_DRO] re:Re: lathe arcs