re:Re: lathe arcs

Carey,

Have you made arcs with your setup before?

Ballendo

P.S. don't rely on any "modal" codes. EXPRESSLY state EVERYthing and
see if that helps. The fact that relative arcs worked somewhat would
seem to put the onus on Doug and CncPRO. BTW, also check for ANY non-
standard text character in the code. And lastly, have you tried a
fresh download/install of the program? Something may have been
corrupted...

--- In CAD_CAM_EDM_DRO@y..., "Carey L. Culpepper" <mr.c@b...> wrote:
> Ballendo: The machine still makes the original "angular" rollers
perfectly. Actually it will do the roughing passes on the parts
> with arcs until it goes for the finish pass. Then it goes nuts.
Everything looks good until it hits the code for an arc. <snip>