Re: [CAD_CAM_EDM_DRO] Re: Sneakernet

Ahhh.... an insider to currupt... it's all going as planned. Now we just
wait until the moons are syncronise with Saturn.

John
(CADMAN, if you read this, try your best to forget it.)

----- Original Message -----
From: <cadman@...>
To: <CAD_CAM_EDM_DRO@yahoogroups.com>
Sent: Wednesday, April 04, 2001 4:27 PM
Subject: [CAD_CAM_EDM_DRO] Re: Sneakernet


> This is becoming very funny... I work for NIKE!!!
>
> CADMAN
>
>
> --- In CAD_CAM_EDM_DRO@y..., Tony Jeffree <tony@j...> wrote:
> > "Sneakernet" refers to the very reliable, high bandwidth network
> created by
> > running between machines (in your best sneakers - must be Nike or a
> > similarly prestigious label, of course) carrying fists full of
> floppy
> > disks, CD Roms, mag tapes, ... etc. You wouldn't find it on the M$
> website
> > because the technology is far too recent... ;-)
> >
> > Actually, with a few DAT tapes in your pocket, you can achieve MUCH
> higher
> > data transfer rates with sneakernet than with 100 Mbit/s Ethernet.
> >
> > Regards,
> > Tony
> >
> > At 07:06 04/04/2001 +0000, you wrote:
> > >Where do you find "sneakernet"? I looked on M$ ftp site.
> > >
> > >CADMAN
> > >
> > >--- In CAD_CAM_EDM_DRO@y..., "Larry Edington" <ledington@c...>
> wrote:
> > > > Yea, there are ways to network the DOS box. But it's just
> > > > not worth the trouble to me. I lived
> > > > through networking from Netware days to Windows days. I've
> > > > run several DOS machines on
> > > > a network. I shall NOT go back to those headaches ever
> > > > again. So sneakernet is the easiest
> > > > and most trouble free solution until all my Cnc controls are
> > > > Windows based.
>
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
> FAQ: http://www.ktmarketing.com/faq.html
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>
>