CAD CAM EDM DRO - Yahoo Group Archive

RE: [CAD_CAM_EDM_DRO] Panel Layout Software

Posted by Donald Kelley
on 2001-04-06 08:23:33 UTC
Peter,
Thanks for this link. It has a demo program that
actually works for my needs. It is limited in numbers
of parts that can be cut but does take into account
kerf etc. I have become interested enough in the quest
for a good nester that I will continue to look.
Again, thanks for the pointer

don

-----Original Message-----
From: Peter Chen [mailto:cadcamcenter@...]
Sent: Thursday, April 05, 2001 6:03 PM
To: CAD_CAM_EDM_DRO@yahoogroups.com
Subject: [CAD_CAM_EDM_DRO] Panel Layout Software


Donald Kelley <dkelley@...>

<Thanks for the responses that I have gotten... I have
looked under 'nesting' and other similar terms.
Although I have found lots of commercial
software(addons, etc), I was looking for something
free(no or low cost) even if it was constrained. ie
2d, no colors, no accounting for kerf etc.>

Try www.woodweb.com
More specifically:
http://www.woodweb.com/Resources/RSSoftwareConnection.html

Peter

____________________________________________________________
Do You Yahoo!?
Get your free @... address at http://mail.yahoo.co.uk
or your free @... address at http://mail.yahoo.ie

Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
discussion of shop built systems, for CAD, CAM, EDM, and DRO.

Addresses:
Post message: CAD_CAM_EDM_DRO@yahoogroups.com
Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
Moderator: jmelson@... timg@... [Moderator]
URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
bill,
List Manager

FAQ: http://www.ktmarketing.com/faq.html

Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/

Discussion Thread

Donald Kelley 2001-04-05 04:52:01 UTC Panel Layout Software John Stevenson 2001-04-05 05:39:49 UTC Re: Panel Layout Software Jon Elson 2001-04-05 11:35:05 UTC Re: [CAD_CAM_EDM_DRO] Panel Layout Software Donald Kelley 2001-04-05 11:43:28 UTC RE: [CAD_CAM_EDM_DRO] Panel Layout Software Peter Chen 2001-04-05 15:03:25 UTC Panel Layout Software Smoke 2001-04-05 18:03:49 UTC Re: [CAD_CAM_EDM_DRO] Panel Layout Software Donald Kelley 2001-04-06 08:23:33 UTC RE: [CAD_CAM_EDM_DRO] Panel Layout Software Peter Chen 2001-04-06 20:59:33 UTC Panel Layout Software Roger Brower 2001-04-07 07:21:33 UTC Panel Layout Software