Re: [CAD_CAM_EDM_DRO] Re: Resetting the head on a Mill Drill
Posted by
Jon Elson
on 2001-04-24 11:17:00 UTC
cadman@... wrote:
enough, once in a while. Of course, I also have the knee to move, so
it isn't a big problem. But, when a part comes along that needs a
1/8" end mill for part of the work, and a 1/2" drill bit for another part,
it becomes a problem. You either need an extended holder for the
1/8" mill, or a cut-down 1/2" drill. A 1/2" jobber's length drill is
pretty long, and when you add the Jacob's chuck, it is more than
5" longer than the small end mill.
Jon
> Now I understand what this thread is all about. One of theWell, I have 5" of quill travel on my Bridgeport, and that still isn't
> requirements of the drill/mill was a large quill travel. The ENCO I
> purchased has 5" of travel. I don't plan to move the head in the
> middle of a job. For my use, 5" of Z travel is fine.
enough, once in a while. Of course, I also have the knee to move, so
it isn't a big problem. But, when a part comes along that needs a
1/8" end mill for part of the work, and a 1/2" drill bit for another part,
it becomes a problem. You either need an extended holder for the
1/8" mill, or a cut-down 1/2" drill. A 1/2" jobber's length drill is
pretty long, and when you add the Jacob's chuck, it is more than
5" longer than the small end mill.
Jon
Discussion Thread
wanliker@a...
2001-04-23 18:58:36 UTC
Re: [CAD_CAM_EDM_DRO]Resetting the head on a Mill Drill
Deon Styger
2001-04-24 00:35:52 UTC
RE: Resetting the head on a Mill Drill
ballendo@y...
2001-04-24 04:38:55 UTC
Re: Resetting the head on a Mill Drill
Carol & Jerry Jankura
2001-04-24 05:49:35 UTC
RE: [CAD_CAM_EDM_DRO] Re: Resetting the head on a Mill Drill
cadman@p...
2001-04-24 08:08:53 UTC
Re: Resetting the head on a Mill Drill
Jerry Kimberlin
2001-04-24 08:25:16 UTC
Re: [CAD_CAM_EDM_DRO] Re: Resetting the head on a Mill Drill
wanliker@a...
2001-04-24 11:11:58 UTC
Re: [CAD_CAM_EDM_DRO] Re: Resetting the head on a Mill Drill
Jon Elson
2001-04-24 11:17:00 UTC
Re: [CAD_CAM_EDM_DRO] Re: Resetting the head on a Mill Drill
stratton@m...
2001-04-24 12:46:57 UTC
Re: [CAD_CAM_EDM_DRO] Re: Resetting the head on a Mill Drill
Bill Phillips
2001-04-24 13:31:47 UTC
Re: [CAD_CAM_EDM_DRO] Re: Resetting the head on a Mill Drill
Smoke
2001-04-24 14:45:16 UTC
Re: [CAD_CAM_EDM_DRO] Re: Resetting the head on a Mill Drill
Deon Styger
2001-04-25 00:39:37 UTC
RE: Resetting the head on a Mill Drill