Re: [CAD_CAM_EDM_DRO] Re: Resetting the head on a Mill Drill
Posted by
Smoke
on 2001-04-24 14:45:16 UTC
You can always chuck and odd diameter drill into a lathe and turn the shank
down to a size that fits one of your tool holders.
Smoke
down to a size that fits one of your tool holders.
Smoke
>But if one needs to use say the 31/64" drill out of the jobber-length
>set on hand, and doesn't have R8 collets by 64ths (who does?) then
>the problem you state is very real!
>
>Chris
Discussion Thread
wanliker@a...
2001-04-23 18:58:36 UTC
Re: [CAD_CAM_EDM_DRO]Resetting the head on a Mill Drill
Deon Styger
2001-04-24 00:35:52 UTC
RE: Resetting the head on a Mill Drill
ballendo@y...
2001-04-24 04:38:55 UTC
Re: Resetting the head on a Mill Drill
Carol & Jerry Jankura
2001-04-24 05:49:35 UTC
RE: [CAD_CAM_EDM_DRO] Re: Resetting the head on a Mill Drill
cadman@p...
2001-04-24 08:08:53 UTC
Re: Resetting the head on a Mill Drill
Jerry Kimberlin
2001-04-24 08:25:16 UTC
Re: [CAD_CAM_EDM_DRO] Re: Resetting the head on a Mill Drill
wanliker@a...
2001-04-24 11:11:58 UTC
Re: [CAD_CAM_EDM_DRO] Re: Resetting the head on a Mill Drill
Jon Elson
2001-04-24 11:17:00 UTC
Re: [CAD_CAM_EDM_DRO] Re: Resetting the head on a Mill Drill
stratton@m...
2001-04-24 12:46:57 UTC
Re: [CAD_CAM_EDM_DRO] Re: Resetting the head on a Mill Drill
Bill Phillips
2001-04-24 13:31:47 UTC
Re: [CAD_CAM_EDM_DRO] Re: Resetting the head on a Mill Drill
Smoke
2001-04-24 14:45:16 UTC
Re: [CAD_CAM_EDM_DRO] Re: Resetting the head on a Mill Drill
Deon Styger
2001-04-25 00:39:37 UTC
RE: Resetting the head on a Mill Drill