Re: [CAD_CAM_EDM_DRO] Re: Resetting the head on a Mill Drill
Posted by
Jerry Kimberlin
on 2001-04-24 08:25:16 UTC
cadman@... wrote:
most purposes it certainly is adequate. But, in a given setup,
you may not be able to change tool holders, collets, etc. without
moving the head. Some tools may be too long to get away from the
workpiece, others may be very different in length or width and
require some resetting. It is unlikely you will only use one
tool to complete a workpiece. This suggests that Z-travel, while
adequate, may may have a different start point for different
tools.
Regards,
JerryK
>I understand what you are saying about the 5" being enough. For
> Now I understand what this thread is all about. One of the
> requirements of the drill/mill was a large quill travel. The ENCO I
> purchased has 5" of travel. I don't plan to move the head in the
> middle of a job. For my use, 5" of Z travel is fine.
most purposes it certainly is adequate. But, in a given setup,
you may not be able to change tool holders, collets, etc. without
moving the head. Some tools may be too long to get away from the
workpiece, others may be very different in length or width and
require some resetting. It is unlikely you will only use one
tool to complete a workpiece. This suggests that Z-travel, while
adequate, may may have a different start point for different
tools.
Regards,
JerryK
Discussion Thread
wanliker@a...
2001-04-23 18:58:36 UTC
Re: [CAD_CAM_EDM_DRO]Resetting the head on a Mill Drill
Deon Styger
2001-04-24 00:35:52 UTC
RE: Resetting the head on a Mill Drill
ballendo@y...
2001-04-24 04:38:55 UTC
Re: Resetting the head on a Mill Drill
Carol & Jerry Jankura
2001-04-24 05:49:35 UTC
RE: [CAD_CAM_EDM_DRO] Re: Resetting the head on a Mill Drill
cadman@p...
2001-04-24 08:08:53 UTC
Re: Resetting the head on a Mill Drill
Jerry Kimberlin
2001-04-24 08:25:16 UTC
Re: [CAD_CAM_EDM_DRO] Re: Resetting the head on a Mill Drill
wanliker@a...
2001-04-24 11:11:58 UTC
Re: [CAD_CAM_EDM_DRO] Re: Resetting the head on a Mill Drill
Jon Elson
2001-04-24 11:17:00 UTC
Re: [CAD_CAM_EDM_DRO] Re: Resetting the head on a Mill Drill
stratton@m...
2001-04-24 12:46:57 UTC
Re: [CAD_CAM_EDM_DRO] Re: Resetting the head on a Mill Drill
Bill Phillips
2001-04-24 13:31:47 UTC
Re: [CAD_CAM_EDM_DRO] Re: Resetting the head on a Mill Drill
Smoke
2001-04-24 14:45:16 UTC
Re: [CAD_CAM_EDM_DRO] Re: Resetting the head on a Mill Drill
Deon Styger
2001-04-25 00:39:37 UTC
RE: Resetting the head on a Mill Drill