CAD CAM EDM DRO - Yahoo Group Archive

Re: I need a latching relay...or do I?

on 2001-04-26 18:19:32 UTC
Mariss,

Sounds good, that should work. Why didn't I think of it, duh?

thanks,

Doug





--- In CAD_CAM_EDM_DRO@y..., mariss92705@y... wrote:
> Hi,
>
> I think you can do what you need with an ordinary relay if it has a
> spare pole. Try this:
>
> 1) Connect the spare NO pole in series with your relay coil.
> 2) Connect your foot pedal NO switch in parallel with the relay NO
> pole.
> 3) Connect the NC limit switch in series with the relay coil.
> 4) Place the whole mess across your AC line.
>
> What will happen is when the foot pedal sw closes, the relay will
> close. Its spare NO pole will close, sustaining coil current even
if
> you release the pedal. It will run the ram until it hits the NC
limit
> sw, which will break coil current because it is in series, dropping
> out the relay.
>
> Mariss
>
>
>

Discussion Thread

dougrasmussen@c... 2001-04-26 16:48:22 UTC I need a latching relay...or do I? mariss92705@y... 2001-04-26 17:14:35 UTC Re: I need a latching relay...or do I? Andy Olney 2001-04-26 17:19:13 UTC RE: [CAD_CAM_EDM_DRO] I need a latching relay...or do I? gordonr@r... 2001-04-26 17:30:03 UTC Re: [CAD_CAM_EDM_DRO] I need a latching relay...or do I? dougrasmussen@c... 2001-04-26 18:19:32 UTC Re: I need a latching relay...or do I? ballendo@y... 2001-04-26 19:03:36 UTC Re: I need a latching relay...or do I? dougrasmussen@c... 2001-04-26 21:39:28 UTC Re: I need a latching relay...or do I? dougrasmussen@c... 2001-04-26 21:41:33 UTC Re: I need a latching relay...or do I? mariss92705@y... 2001-04-26 22:15:08 UTC Re: I need a latching relay...or do I? ptengin@a... 2001-04-27 02:41:58 UTC Re: [CAD_CAM_EDM_DRO] I need a latching relay...or do I? Smoke 2001-04-27 07:31:04 UTC Re: [CAD_CAM_EDM_DRO] Re: I need a latching relay...or do I? dave engvall 2001-05-05 07:37:11 UTC Re: [CAD_CAM_EDM_DRO] Re: I need a latching relay...or do I? dougrasmussen@c... 2001-05-05 08:22:39 UTC Re: I need a latching relay...or do I? ballendo@y... 2001-05-05 16:58:38 UTC pressure vs. feed B/Saw pwr dnfeed was Re: I need a latching relay...or do I? dave engvall 2001-05-08 09:10:58 UTC Re: [CAD_CAM_EDM_DRO] Re: I need a latching relay...or do I?