CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Re: I need a latching relay...or do I?

Posted by dave engvall
on 2001-05-05 07:37:11 UTC
Doug,

Consistent feed rate should come from a motor not
a hyraulic cylinder which would give consistent
pressure or force. Not quite the same thing.
Maybe a dc motor with speed control driving a
screw or ball-screw.
Naturally, once you get hydraulics set for a
given cut it should be OK.

Sorry that I think different or am so picky. Just
the way it is.

Dave

Discussion Thread

dougrasmussen@c... 2001-04-26 16:48:22 UTC I need a latching relay...or do I? mariss92705@y... 2001-04-26 17:14:35 UTC Re: I need a latching relay...or do I? Andy Olney 2001-04-26 17:19:13 UTC RE: [CAD_CAM_EDM_DRO] I need a latching relay...or do I? gordonr@r... 2001-04-26 17:30:03 UTC Re: [CAD_CAM_EDM_DRO] I need a latching relay...or do I? dougrasmussen@c... 2001-04-26 18:19:32 UTC Re: I need a latching relay...or do I? ballendo@y... 2001-04-26 19:03:36 UTC Re: I need a latching relay...or do I? dougrasmussen@c... 2001-04-26 21:39:28 UTC Re: I need a latching relay...or do I? dougrasmussen@c... 2001-04-26 21:41:33 UTC Re: I need a latching relay...or do I? mariss92705@y... 2001-04-26 22:15:08 UTC Re: I need a latching relay...or do I? ptengin@a... 2001-04-27 02:41:58 UTC Re: [CAD_CAM_EDM_DRO] I need a latching relay...or do I? Smoke 2001-04-27 07:31:04 UTC Re: [CAD_CAM_EDM_DRO] Re: I need a latching relay...or do I? dave engvall 2001-05-05 07:37:11 UTC Re: [CAD_CAM_EDM_DRO] Re: I need a latching relay...or do I? dougrasmussen@c... 2001-05-05 08:22:39 UTC Re: I need a latching relay...or do I? ballendo@y... 2001-05-05 16:58:38 UTC pressure vs. feed B/Saw pwr dnfeed was Re: I need a latching relay...or do I? dave engvall 2001-05-08 09:10:58 UTC Re: [CAD_CAM_EDM_DRO] Re: I need a latching relay...or do I?