CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] ini file for EMC

Posted by Terry Toddy
on 2001-05-02 05:23:48 UTC
Thanks Tim.

Now if I can just get it out of E-Stop. I changed the polarity on the
E-Stop input but it is still comes up stuck in E-Stop. Is there some
place you can look to see the actual status of the inputs and outputs?

Terry

Tim Goldstein wrote:
>
> That is relatively easy. If you are running freqmod you have to have a
> parameter:
> PERIOD = 0.000016
> (the value can be changed for the system, lower numbers demand more
> processor power, but give better results). In the .ini I just looked at it
> is the last parameter before the [TRAJ] section.
>
> If you are in steppermod you have to remove or comment this parameter out.
>
> Tim
> [Denver, CO]
>
> > -----Original Message-----
>
> > It says something about PERIOD parameter definition.
> >
> > I don't have the excact error message available, my EMC box is at home
> > and I am at work.
> >
> > Terry

Discussion Thread

Terry Toddy 2001-05-01 05:37:19 UTC ini file for EMC Tim Goldstein 2001-05-01 09:50:49 UTC RE: [CAD_CAM_EDM_DRO] ini file for EMC Terry Toddy 2001-05-01 14:11:13 UTC Re: [CAD_CAM_EDM_DRO] ini file for EMC Terry Toddy 2001-05-01 16:17:57 UTC Re: [CAD_CAM_EDM_DRO] ini file for EMC Tim Goldstein 2001-05-01 17:43:23 UTC RE: [CAD_CAM_EDM_DRO] ini file for EMC timg@k... 2001-05-01 18:15:31 UTC Re: ini file for EMC Terry Toddy 2001-05-02 05:23:48 UTC Re: [CAD_CAM_EDM_DRO] ini file for EMC Ian Wright 2001-05-02 07:21:58 UTC Re: [CAD_CAM_EDM_DRO] ini file for EMC Tim Goldstein 2001-05-02 09:06:12 UTC RE: [CAD_CAM_EDM_DRO] ini file for EMC Terry Toddy 2001-05-02 11:25:34 UTC Re: [CAD_CAM_EDM_DRO] ini file for EMC jmelson 2001-05-02 12:02:05 UTC Re: [CAD_CAM_EDM_DRO] ini file for EMC