Re: [CAD_CAM_EDM_DRO] BoBCad Question

In a message dated 5/6/01 12:31:46 AM Eastern Daylight Time,
fenerty@... writes:

> Hi:
>
> I have a customer who normally uses flashcut and is finding that
> Canned Cycles are not the same code as the EMC equivalent. Does anyone know
> how to make BobCad put out NIST274 G-code. Is there a specific postprocessor
> that can do it?
>
> Thanks,
> Art
>
>
>

Art:

For that answer I think you will need to contact BobCad directly. But every
controller that I have ever worked with uses the G80, G81, etc., for the
canned cycles, what does EMC use, I haven't used EMC myself but I know that
Fanuc, Allen-Bradley, Bosch, NUM all use the regular G80, G81, G88, etc.,
commands for canned cycles and I would think EMC uses the accepted industry
norm for them as well.

Regards,

Randy Abernathy
Woodworking Machinery Specialist
4626 Old Stilesboro Road NW
Acworth, GA 30101
Phone / Fax: 770-974-5295
E-mail: cnc002@...


[Non-text portions of this message have been removed]