CAD CAM EDM DRO - Yahoo Group Archive

Re: machining ballscrews

Posted by ballendo@y...
on 2001-05-10 03:37:07 UTC
Chris,

Do you have some feeds/speeds/insert types for us to use doing this?

Thank you in advance.

Ballendo

--- In CAD_CAM_EDM_DRO@y..., stratton@m... wrote:
> Screws really can be machined in hard form with carbide inserts.
> True, you have to go slow until you get below the thread root, but
it
> really isn't that bad.
> Chris

Discussion Thread

carlcnc@e... 2001-05-09 06:36:00 UTC machining ballscrews Joe Vicars 2001-05-09 06:49:19 UTC Re: [CAD_CAM_EDM_DRO] machining ballscrews stratton@m... 2001-05-09 07:19:43 UTC Re: [CAD_CAM_EDM_DRO] machining ballscrews Mike 2001-05-09 13:03:41 UTC Re: [CAD_CAM_EDM_DRO] machining ballscrews Les Watts 2001-05-09 17:20:06 UTC Re: [CAD_CAM_EDM_DRO] machining ballscrews Doug Harrison 2001-05-09 19:29:42 UTC Re: [CAD_CAM_EDM_DRO] machining ballscrews ballendo@y... 2001-05-10 03:37:07 UTC Re: machining ballscrews ballendo@y... 2001-05-10 05:09:10 UTC Re: machining ballscrews stratton@m... 2001-05-10 05:55:11 UTC Re: [CAD_CAM_EDM_DRO] Re: machining ballscrews Tim Goldstein 2001-05-10 10:53:47 UTC RE: [CAD_CAM_EDM_DRO] Re: machining ballscrews Doug Harrison 2001-05-10 16:40:04 UTC Re: [CAD_CAM_EDM_DRO] Re: machining ballscrews Sven Peter, TAD S.A. 2001-05-11 12:54:21 UTC Re: [CAD_CAM_EDM_DRO] machining ballscrews ballendo@y... 2001-05-12 05:41:58 UTC Re: machining ballscrews ballendo@y... 2001-05-12 07:28:08 UTC Re: machining ballscrews