CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Re: machining ballscrews

Posted by Doug Harrison
on 2001-05-10 16:40:04 UTC
----- Original Message -----
From: <ballendo@...>

> Doug,
>
> THANK YOU for sharing this. Is the good man a member of our group?
>
> Ballendo

I dunno! He might be lurking, afraid I will bombard him with questions
again if he surfaces.

Doug

Discussion Thread

carlcnc@e... 2001-05-09 06:36:00 UTC machining ballscrews Joe Vicars 2001-05-09 06:49:19 UTC Re: [CAD_CAM_EDM_DRO] machining ballscrews stratton@m... 2001-05-09 07:19:43 UTC Re: [CAD_CAM_EDM_DRO] machining ballscrews Mike 2001-05-09 13:03:41 UTC Re: [CAD_CAM_EDM_DRO] machining ballscrews Les Watts 2001-05-09 17:20:06 UTC Re: [CAD_CAM_EDM_DRO] machining ballscrews Doug Harrison 2001-05-09 19:29:42 UTC Re: [CAD_CAM_EDM_DRO] machining ballscrews ballendo@y... 2001-05-10 03:37:07 UTC Re: machining ballscrews ballendo@y... 2001-05-10 05:09:10 UTC Re: machining ballscrews stratton@m... 2001-05-10 05:55:11 UTC Re: [CAD_CAM_EDM_DRO] Re: machining ballscrews Tim Goldstein 2001-05-10 10:53:47 UTC RE: [CAD_CAM_EDM_DRO] Re: machining ballscrews Doug Harrison 2001-05-10 16:40:04 UTC Re: [CAD_CAM_EDM_DRO] Re: machining ballscrews Sven Peter, TAD S.A. 2001-05-11 12:54:21 UTC Re: [CAD_CAM_EDM_DRO] machining ballscrews ballendo@y... 2001-05-12 05:41:58 UTC Re: machining ballscrews ballendo@y... 2001-05-12 07:28:08 UTC Re: machining ballscrews