Re: [CAD_CAM_EDM_DRO] Am I missing something?
Posted by
Alan Marconett KM6VV
on 2001-05-22 10:39:57 UTC
Hi John,
That's mostly correct. CNCpro, and most others do not use a signal
generator. Desk NC for windows (just coming out) does (comes with the
software).
I'd like to recommend you get the Sherline motor mount kit. Comes with
a new Z lead screw (or it did), and is the best I've seen and used.
Alan KM6VV
info.host@... wrote:
That's mostly correct. CNCpro, and most others do not use a signal
generator. Desk NC for windows (just coming out) does (comes with the
software).
I'd like to recommend you get the Sherline motor mount kit. Comes with
a new Z lead screw (or it did), and is the best I've seen and used.
Alan KM6VV
info.host@... wrote:
>
> Thanks for all the replies so far. The mounts do not come with the Sherline
> but are something like $180; the ones from FlashCut, that are hollow so you
> can see through them, are $200 or so. If I was driving the steppers through
> a DOS program then I would not need a signal generator? And I'd be looking
> for an 80v @ 8amp power supply to drive four steppers?
>
> Thanks again,
> John H.
Discussion Thread
info.host@b...
2001-05-21 17:16:16 UTC
Am I missing something?
Doug Fortune
2001-05-21 17:49:09 UTC
Am I missing something?
cadcamcenter@y...
2001-05-21 18:11:39 UTC
Re: Am I missing something?
Alan Marconett KM6VV
2001-05-21 18:30:56 UTC
Re: [CAD_CAM_EDM_DRO] Am I missing something?
Carol & Jerry Jankura
2001-05-21 18:34:33 UTC
RE: [CAD_CAM_EDM_DRO] Am I missing something?
ron ginger
2001-05-21 19:04:56 UTC
Re: Am I missing something?
Carol & Jerry Jankura
2001-05-21 19:11:28 UTC
RE: [CAD_CAM_EDM_DRO] Am I missing something?
Chris Stratton
2001-05-21 19:28:52 UTC
Re: [CAD_CAM_EDM_DRO] Re: Am I missing something?
Tim Goldstein
2001-05-21 22:34:07 UTC
RE: [CAD_CAM_EDM_DRO] Am I missing something?
info.host@b...
2001-05-22 05:52:05 UTC
Re: [CAD_CAM_EDM_DRO] Am I missing something?
Joe Vicars
2001-05-22 07:21:09 UTC
Re: [CAD_CAM_EDM_DRO] Am I missing something?
Alan Marconett KM6VV
2001-05-22 10:39:57 UTC
Re: [CAD_CAM_EDM_DRO] Am I missing something?
Tim Goldstein
2001-05-22 11:18:49 UTC
RE: [CAD_CAM_EDM_DRO] Am I missing something?
Alan Marconett KM6VV
2001-05-22 11:35:23 UTC
Re: [CAD_CAM_EDM_DRO] Am I missing something?
ballendo@y...
2001-05-24 15:37:16 UTC
Re: Am I missing something?