CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Am I missing something?

on 2001-05-22 05:52:05 UTC
Thanks for all the replies so far. The mounts do not come with the Sherline
but are something like $180; the ones from FlashCut, that are hollow so you
can see through them, are $200 or so. If I was driving the steppers through
a DOS program then I would not need a signal generator? And I'd be looking
for an 80v @ 8amp power supply to drive four steppers?

Thanks again,
John H.

Discussion Thread

info.host@b... 2001-05-21 17:16:16 UTC Am I missing something? Doug Fortune 2001-05-21 17:49:09 UTC Am I missing something? cadcamcenter@y... 2001-05-21 18:11:39 UTC Re: Am I missing something? Alan Marconett KM6VV 2001-05-21 18:30:56 UTC Re: [CAD_CAM_EDM_DRO] Am I missing something? Carol & Jerry Jankura 2001-05-21 18:34:33 UTC RE: [CAD_CAM_EDM_DRO] Am I missing something? ron ginger 2001-05-21 19:04:56 UTC Re: Am I missing something? Carol & Jerry Jankura 2001-05-21 19:11:28 UTC RE: [CAD_CAM_EDM_DRO] Am I missing something? Chris Stratton 2001-05-21 19:28:52 UTC Re: [CAD_CAM_EDM_DRO] Re: Am I missing something? Tim Goldstein 2001-05-21 22:34:07 UTC RE: [CAD_CAM_EDM_DRO] Am I missing something? info.host@b... 2001-05-22 05:52:05 UTC Re: [CAD_CAM_EDM_DRO] Am I missing something? Joe Vicars 2001-05-22 07:21:09 UTC Re: [CAD_CAM_EDM_DRO] Am I missing something? Alan Marconett KM6VV 2001-05-22 10:39:57 UTC Re: [CAD_CAM_EDM_DRO] Am I missing something? Tim Goldstein 2001-05-22 11:18:49 UTC RE: [CAD_CAM_EDM_DRO] Am I missing something? Alan Marconett KM6VV 2001-05-22 11:35:23 UTC Re: [CAD_CAM_EDM_DRO] Am I missing something? ballendo@y... 2001-05-24 15:37:16 UTC Re: Am I missing something?