CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Drill-Mill CNC conversion design.

Posted by Randy Gordon-Gilmore
on 2001-05-30 13:14:00 UTC
At 01:02 PM 5/30/2001 -0700, Alan wrote:

>4.7. Any Ideas? The other pix on the site come up great!

CADMAN, you need to replace the "\" in the picture URL's with "/" on the
ballscrew conversion page.

Best regards,

Randy

Randy Gordon-Gilmore ,----.___________ ______________ _________________
ProtoTrains // = = === == || == == == = || == == == = == =|
Rio Vista, CA, USA /-O==O------------o==o------------o==o-----------o==o-'
zephyrus@... http://www.rickadee.net/~zephyrus

Discussion Thread

cadman@p... 2001-05-30 07:50:35 UTC Drill-Mill CNC conversion design. Hugh Prescott 2001-05-30 08:28:50 UTC Re: [CAD_CAM_EDM_DRO] Drill-Mill CNC conversion design. cadman@p... 2001-05-30 08:35:57 UTC Re: Drill-Mill CNC conversion design. Drew Rogge 2001-05-30 08:38:12 UTC Re: [CAD_CAM_EDM_DRO] Drill-Mill CNC conversion design. Carlos Guillermo 2001-05-30 09:33:29 UTC RE: [CAD_CAM_EDM_DRO] Drill-Mill CNC conversion design. cadman@p... 2001-05-30 10:34:03 UTC Re: Drill-Mill CNC conversion design. allan_r9@h... 2001-05-30 11:17:28 UTC Re: Drill-Mill CNC conversion design. cadman@p... 2001-05-30 11:49:11 UTC Re: Drill-Mill CNC conversion design. Hugh Currin 2001-05-30 12:28:15 UTC Re: Drill-Mill CNC conversion design. Alan Marconett KM6VV 2001-05-30 13:01:44 UTC Re: [CAD_CAM_EDM_DRO] Drill-Mill CNC conversion design. Randy Gordon-Gilmore 2001-05-30 13:14:00 UTC Re: [CAD_CAM_EDM_DRO] Drill-Mill CNC conversion design. Rich D. 2001-05-30 13:56:25 UTC Re: [CAD_CAM_EDM_DRO] Drill-Mill CNC conversion design. cadman@p... 2001-05-30 14:33:45 UTC Re: Drill-Mill CNC conversion design. Try Again :) Alan Marconett KM6VV 2001-05-30 15:57:39 UTC Re: [CAD_CAM_EDM_DRO] Drill-Mill CNC conversion design. Sven Peter, TAD S.A. 2001-05-30 20:52:54 UTC Re: [CAD_CAM_EDM_DRO] Drill-Mill CNC conversion design. Joel Jacobs 2001-05-31 07:39:03 UTC Re: [CAD_CAM_EDM_DRO] Drill-Mill CNC conversion design.