Re: [CAD_CAM_EDM_DRO] Text editing in DOS

Gentlemen,

I am looking for a DOS program which will allow my GCode text files to be
"browsed". I remember when DBASE II first came out, their brouse command
would allow one to scan up and down through a file. In this case, I would
like to be able to browse through a DOS subdirectory, and have the file name
displayed on the left, and the first line of text of the file displayed on
the same line as the file name, so that I can see the comment I put at the
beginning of the file (to see what the G Code file was used for. After a
while, I forget what the eight character file name means. Is there some
utility which will allow this to be done, or is this a feature that can only
be programmed inside an application?

Thanks,

Tom E.

----- Original Message -----
From: Gail & Bryan Harries <gab@...>

> In my Net travels I came across a freeware DOS based ASCII text editor
that
> I thought may be of interest to those of you that hate Windoz...
>
> > "Pedit is a freeware DOS editor similar to, but better than the standard
DOS
> edit program."
>
> http://www.goldshell.com/pedit/main.htm
>
> I hope someone finds this of use.
>
> Regards,
> Bryan
>
>
>
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>
> Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
> FAQ: http://www.ktmarketing.com/faq.html
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>
>