Re: Re: 03-Sep-1999.tgz
Posted by
Fred Proctor
on 1999-09-15 11:17:01 UTC
Tim Goldstein wrote:
combinations of task and IO controllers, and noted that if I ran
bridgeporttask (aka shvtask) and minimillio (aka mmio), I could load a
program but it aborted before running any motion. MDI worked OK for a
linear move. Note that one should not mix bridgeport* and minimill*
programs since they are tailored for different machines and it doesn't
make sense to mix them.
I did this using a previous script I had (stepper.run, with
stepper.ini), and for a new script (emc.run, with emc.ini, based on the
new generic.run,ini files).
Tim, send me your run script and ini file and perhaps I can duplicate
the problem here.
--Fred
> I just loaded the 14-sep-1999 release on my backup system and I am havingI ran it on my machine here and it ran OK. I tried some different
> some major problems. I made no changes to my run or ini files. When I start
> EMC it comes up just fine, but once I am in the Xemc interface I can't load
> a program in auto mode and in MDI or manual I can't get it to show that it
> is generating any motion (coordinates do not change).
combinations of task and IO controllers, and noted that if I ran
bridgeporttask (aka shvtask) and minimillio (aka mmio), I could load a
program but it aborted before running any motion. MDI worked OK for a
linear move. Note that one should not mix bridgeport* and minimill*
programs since they are tailored for different machines and it doesn't
make sense to mix them.
I did this using a previous script I had (stepper.run, with
stepper.ini), and for a new script (emc.run, with emc.ini, based on the
new generic.run,ini files).
Tim, send me your run script and ini file and perhaps I can duplicate
the problem here.
--Fred
Discussion Thread
Fred Proctor
1999-09-14 06:32:45 UTC
Re: 03-Sep-1999.tgz
Tim Goldstein
1999-09-14 20:44:55 UTC
RE: Re: 03-Sep-1999.tgz
Ray Henry
1999-09-15 09:55:13 UTC
Re: Re: 03-Sep-1999.tgz
Tim Goldstein
1999-09-15 11:09:13 UTC
Re: Re: Re: 03-Sep-1999.tgz
Fred Proctor
1999-09-15 11:17:01 UTC
Re: Re: 03-Sep-1999.tgz
Paul Corner
1999-09-15 14:23:07 UTC
Re: Re: 03-Sep-1999.tgz