CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Re: First note-Help

on 2001-06-29 20:14:10 UTC
Jan
that is all the secret good service engineers earn their
living with. And very well recognized factories often
make similar mistakes. But don't believe the construction
department will listen to your recommendations as a "simple"
field engineer.
The only occasion a development department listened to
my recommendation and developed a simple fool proof
bread and butter product the sales department still doesn't promote it
because it is "under the clients expectations" {better said" it wasn't our idea"}

Life is hard but unfair.
Best Luck
Sven Peter

(the above mentioned product is the LRP4 from Kieback & Peter
who needs a cheap and reliable air-condition controller will love it.
Lots of extras in the software! {to be sincere: I only gave the idea})

JanRwl@... wrote:

> In a message dated 29-Jun-01 16:06:53 Central Daylight Time,
> mariss92705@... writes:
>
> > The cure was to place a .1 uF multilayer ceramic capacitor across the
> > encoder's +5VDC and GND lines, at the encoder itself. Problem
> > disappeared entirely!
> >
>
> It always blows me away when a MANUFACTURING FIRM doing "high-tech" will omit
> some TINY inexpensive parts so OBVIOUSLY needed for such! Mariss, or anyone:
> Can you comment instructively on this point???
>


[Non-text portions of this message have been removed]

Discussion Thread

Wolfy360 2001-06-29 05:33:53 UTC First note-Help Tom Eldredge 2001-06-29 07:29:38 UTC Re: [CAD_CAM_EDM_DRO] First note-Help Tim Goldstein 2001-06-29 08:53:53 UTC RE: [CAD_CAM_EDM_DRO] First note-Help mariss92705@y... 2001-06-29 09:06:28 UTC Re: First note-Help JanRwl@A... 2001-06-29 19:05:13 UTC Re: [CAD_CAM_EDM_DRO] Re: First note-Help Sven Peter, TAD S.A. 2001-06-29 20:14:10 UTC Re: [CAD_CAM_EDM_DRO] Re: First note-Help Jon Elson 2001-06-29 21:49:22 UTC Re: [CAD_CAM_EDM_DRO] Re: First note-Help mariss92705@y... 2001-06-30 00:43:21 UTC Re: First note-Help PMeinhard@a... 2001-06-30 03:24:58 UTC Re: [CAD_CAM_EDM_DRO] Re: First note-Help Tom Eldredge 2001-06-30 03:53:43 UTC Re: [CAD_CAM_EDM_DRO] Re: First note-Help Chris Stratton 2001-06-30 10:23:22 UTC Re: [CAD_CAM_EDM_DRO] Re: First note-Help