Re: [CAD_CAM_EDM_DRO] Re: Fanuc

Hi, i wish i knew where to find a fanuc model #. it is a tape unit,they have
3 lathes and 2 have a crt this one does not but all have tape units. I found
the problem and it is running, enough so they need to get hydraulic power up
to do more testing. There is a bunch of numbers on the fanuc control itself.
I will try to find out what the other 2 are as they have documentation for
the 2 with crt. thanks brian f.

----- Original Message -----
From: "Donald Brock" <don.pat.brock@...>
To: <CAD_CAM_EDM_DRO@yahoogroups.com>
Sent: Saturday, July 14, 2001 8:44 PM
Subject: [CAD_CAM_EDM_DRO] Re: Fanuc


> Fanuc without a crt? Is this a 5T or earlier unit?
>
> Donald Brock
>
>
> --- In CAD_CAM_EDM_DRO@y..., "brian" <ka1bbg1@m...> wrote:
> > Ok, my buddy has a shop with screw machines,54 or more. one of the
> new machines is a lathe with a fanuc controller without a crt. It was
> disconnected and reconnected at his shop but it will not do anything
> so I have been called. can anyone "fanuc" me. give me a few simple
> commands etc? cul brian f.
> >
> >
> > [Non-text portions of this message have been removed]
>
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>
> Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
>
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>
>