Re: [CAD_CAM_EDM_DRO] DC brush motor life
Posted by
Jon Elson
on 2001-07-21 23:33:01 UTC
Carlos Guillermo wrote:
on a set of brushes. Unless the brushes and/or commutator are
horribly made, I can't imagine any rapid wear on them. I know I run
my shop vac pretty hard, and the brushes outlast everything else
in the motor (bearings, plastic motor housings, armature, etc.)
Due to the RPM, the brushes in a shop vac are probably under even
worse stress than in a 3000-5000 RPM motor.
Jon
> OK, didn't get any feedback the first time, so here goes again:I would expect that you should be able to get several years of operation
>
> Does anyone know anything about the life of the brushes in a motor
> like the recently discussed Surplus Center 2.5 HP motor with the
> KB controller? Very ballpark / order of magnitude is OK.
on a set of brushes. Unless the brushes and/or commutator are
horribly made, I can't imagine any rapid wear on them. I know I run
my shop vac pretty hard, and the brushes outlast everything else
in the motor (bearings, plastic motor housings, armature, etc.)
Due to the RPM, the brushes in a shop vac are probably under even
worse stress than in a 3000-5000 RPM motor.
Jon
Discussion Thread
Carlos Guillermo
2001-07-21 16:27:50 UTC
DC brush motor life
Doug Harrison
2001-07-21 17:33:47 UTC
Re: [CAD_CAM_EDM_DRO] DC brush motor life
Gail & Bryan Harries
2001-07-21 17:46:15 UTC
RE: [CAD_CAM_EDM_DRO] DC brush motor life
brian
2001-07-21 19:18:48 UTC
Re: [CAD_CAM_EDM_DRO] DC brush motor life
Jon Elson
2001-07-21 23:33:01 UTC
Re: [CAD_CAM_EDM_DRO] DC brush motor life