Re: Introduction/Ideas/Questions
Posted by
Jon Elson
on 1999-09-24 15:50:11 UTC
PTENGIN@... wrote:
compound slide should make the machine a bit MORE rigid. A Hardinge
is awfully good, but my Atlas (Ewww, yuck!) needs all the help it can get.
Jon
> From: PTENGIN@...Attaching MORE slides will make the machine LESS rigid. Removing the
>
> In a message dated 09/24/1999 10:28:02 AM Hawaiian Standard Time,
> stratton@... writes:
>
> << Once I get tired of "manual numerical control" I really want to put a
> drive on at least the crossfeed. >>
> Chris,
> I have an Upgrade Tech CNC package mounted on a Hardinge Dv-59. It works
> very well. Main point though is that there is no modifications to the base
> machine. I'm wondering if a small XZ table retrofitted with ball screws and
> steppers, bolted to the bed would not be a better solution than permanent
> mods to the SB. This would leave the machine able to do larger manual jobs if
> the need arrises.
compound slide should make the machine a bit MORE rigid. A Hardinge
is awfully good, but my Atlas (Ewww, yuck!) needs all the help it can get.
Jon
Discussion Thread
stratton@x...
1999-09-24 13:27:55 UTC
Introduction/Ideas/Questions
PTENGIN@a...
1999-09-24 14:31:05 UTC
Re: Introduction/Ideas/Questions
stratton@m...
1999-09-24 15:05:02 UTC
Re: Introduction/Ideas/Questions
Jon Elson
1999-09-24 15:24:22 UTC
Re: Introduction/Ideas/Questions
Jon Elson
1999-09-24 15:50:11 UTC
Re: Introduction/Ideas/Questions
Jon Anderson
1999-09-24 18:30:34 UTC
Re: Introduction/Ideas/Questions
PTENGIN@x...
1999-09-25 10:34:50 UTC
Re: Introduction/Ideas/Questions