RE: Re: Cheap interface boards
Posted by
David Howland
on 1999-09-28 07:50:09 UTC
James, An interesting site for Parallel port stepper control software is:
htt://www.abilitysystems.com/indexlpt.htm
-----Original Message-----
From: James Eckman [SMTP:fugu@...]
Sent: Tuesday, September 28, 1999 6:26 AM
To: CAD_CAM_EDM_DRO@onelist.com
Subject: [CAD_CAM_EDM_DRO] Re: Cheap interface boards
From: James Eckman <fugu@...>
Good ideas on the low cost interface boards. Anything that's commonly
used in a PC is going to be dirt cheap, if it works for you that's not a
bad approach. I do seem to remember some 4/6 axis quadrature card built
by some no name company for something like $200. This was several years
ago and I can't remember the name. A search through magazines like
Embedded Systems or Circuit Cellar may turn up some low cost cards like
this. Since my first home NC project is going to be steppers running
open loop, the printer port is more than adequate for me!
Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the discussion of shop built systems in the above catagories.
To Unsubscribe, read archives, change to or from digest.
Go to: http://www.onelist.com/isregistered.cgi
Log on, and you will go to Member Center, and you can make changes there.
For the FAQ, go to http://www.ktmarketing.com/faq.html
bill,
List Manager
htt://www.abilitysystems.com/indexlpt.htm
-----Original Message-----
From: James Eckman [SMTP:fugu@...]
Sent: Tuesday, September 28, 1999 6:26 AM
To: CAD_CAM_EDM_DRO@onelist.com
Subject: [CAD_CAM_EDM_DRO] Re: Cheap interface boards
From: James Eckman <fugu@...>
Good ideas on the low cost interface boards. Anything that's commonly
used in a PC is going to be dirt cheap, if it works for you that's not a
bad approach. I do seem to remember some 4/6 axis quadrature card built
by some no name company for something like $200. This was several years
ago and I can't remember the name. A search through magazines like
Embedded Systems or Circuit Cellar may turn up some low cost cards like
this. Since my first home NC project is going to be steppers running
open loop, the printer port is more than adequate for me!
Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the discussion of shop built systems in the above catagories.
To Unsubscribe, read archives, change to or from digest.
Go to: http://www.onelist.com/isregistered.cgi
Log on, and you will go to Member Center, and you can make changes there.
For the FAQ, go to http://www.ktmarketing.com/faq.html
bill,
List Manager
Discussion Thread
James Eckman
1999-09-28 06:25:41 UTC
Re: Cheap interface boards
David Howland
1999-09-28 07:50:09 UTC
RE: Re: Cheap interface boards
batwings@x...
1999-09-28 00:56:41 UTC
RE: Re: Cheap interface boards
James Eckman
1999-09-29 08:44:01 UTC
Re: RE: Re: Cheap interface boards
David Howland
1999-09-29 09:40:11 UTC
RE: Re: RE: Re: Cheap interface boards
batwings@i...
1999-09-29 07:30:19 UTC
RE: Re: RE: Re: Cheap interface boards